Jmicron Jmb362 Driver For Mac
When using JMicron36xSATA.kext all drives connected to the JMicron controllers will be displayed on the desktop as internal disks, just like the Intel connected drives. But if you use the JMicron36xeSATA.kext, then they show up on the desktop as external (orange) disks and can be hot swapped.
After hours of trying to make eSATA work with my new JMB363 PCIe Card i am frustrated. There seems to be no way to configure it to use pure AHCI, the card uses Legacy-IDE-AHCI on the eSATA ports.
In pure AHCI Mode there should be two PCI Devices (one SATA, one IDE), mine is recognised as ONE device: 02:00.0 SATA controller: JMicron Technologies, Inc. JMicron 3 AHCI Controller (rev 03) (prog-if 01 [AHCI 1.0]) Subsystem: JMicron Technologies, Inc.
Epson Driver For Mac
JMicron 3 AHCI Controller Flags: bus master, fast devsel, latency 0, IRQ 16 I/O ports at c000 I/O ports at c100 I/O ports at c200 I/O ports at c300 I/O ports at c400 Memory at f8000000 (32-bit, non-prefetchable) Capabilities: [68] Power Management version 2 Capabilities: [50] Express Legacy Endpoint, MSI 01 Capabilities: [100] #197b Capabilities: [236] #68. For the Archives: After many hours of reading and trying i got my JMicron JMB363 PCIe Card working as wanted. Some PCI Registers need to be set, so that the Card works in Dual Function Mode. One PCI Device has the SATA AHCI Function, the other one the Legacy IDE Function. This Dual Function Mode is needed to get AHCI working. Lspci: 02:00.0 SATA controller: JMicron Technologies, Inc. JMicron 3 AHCI Controller (rev 03) 02:00.1 IDE interface: JMicron Technologies, Inc.
